The holddown pin must be inserted into the center of each side of the bottomrail. Use a mallet or hammer, the pin will burr in. The blind will not tilt properly if the pin is not centered correctly.

The holddown bracket is installed into the door or wall behind the bottomrail. The bracket should extend out to meet the holddown pin. Install the holddown bracket close enough to the bottomrail so that the holddown pin is caught in it’s designated space/hole on the holddown bracket.

For 2-1/2” ShutterBlinds—Place the holddown pin 1/4” closer to the back of the bottomrail. The headrail and bottomrail are only 2”, while the slats are 2-1/2”; requiring you to use 1/4” spacer blocks behind the headrail so that the blind will hang straight. Therefore, adjust the holddown pins 1/4” from the center towards the back of the bottomrail.

Although we do our best to make sure that the colors shown on our web site are accurate, actual colors
can vary slightly. In addition, subtle color differences and textures may not be fully appreciated on some systems.
Dye lots can vary on some blinds. Due to the fact that our products are all custom made, and CAN'T BE RETURNED,
you may wish to have a sample sent to you before ordering.

SellBlinds.com • ByteMeDomains.com • Ozark, Missouri • USA • 417-429-1633

Sales and Customer Service can be reached 9:00am to 5:00pm, CST, Monday through Friday by email or telephone.
Trademarks mentioned on this site belong to their respective owners, even if not clearly identified.
We value your privacy and do not sell or provide your personal information to other companies.

web development: ByteMeDomains.com